Service Support Spirit
Unique Solution
WWW.ARCBRO.COM
78
8.7.6.3 Default IJ Coordinate
As the figure 8.12 shows, in the G code of G02 or G03, I or J parameter after the code is
relative coordinate or absolute coordinate. Under the general circumstance, the arc’s IJ
coordinate is relative coordinate, only minority several G code of arc’s IJ coordinate is absolute
coordinate.
8.7.6.4 Switch between Metric and Inches
As the figure 8.12 shows, default unit can be switched to either the metric or the inches,
after switching, the data’s units about length are all switched.
8.7.6.5 Short Line Fitting
As the figure 8.12 shows, when short line segments in the G code are too many and
continuous shake or shock occurs in the process of machine tool runs, set this parameter ”
Yes ”, in the general condition this parameter is set “No”.
8.7.6.6 Steel Plate Angle Memory
In the default condition, the angle after steel plate is adjusted has no memory. After this
parameter is set “Yes”, steel plate angle memory will be automatically stored, until the steel plate
is adjust again or the angle is cleared. As the figure 8.12 shows
，
when short line segments in
the G code are too many and continuous shake or shock occurs in the process of machine tool
runs, set this parameter ” Yes ”, in the general condition this parameter is set “No”.
8.7.6.7 F Instruction Forbidden
When this parameter is “Yes”, F instruction after G code which is used for limited rate is
ignored.
8.7.6.8 Manual Angle Input to Adjust Steel Plate
When this parameter is “Yes”, the manual input angle in the section of 4.3.3 is also steel
plate adjusting angle. This angle will be shown in the main interface, if open the function of steel
plate angle memory, this angle is also add to the steel plate adjust angle and accordingly saved.
8.7.7 Language Switch
In the main interface, press
【
F5 Diagnose
】
,then press
【
F8 System definition
】
,then
press
【
F6 Language
】
, it will select needed language interface.
