Service Support Spirit
Unique Solution
WWW.ARCBRO.COM
52
Each edit line supports 128 characters maximum.
When you open a file on U disk or new a code file, you must save it as the local machine
code before you start cutting. Otherwise, you cannot make use of the breakpoint recovery
function or power off protection function.
After edit the code , press
【
F8
】
to save the code.
6.5 New File
In the editing code interface (refer to 6.4 edit code ), you can press key
【
F4
】
to create an
new file to input your own code.
6.6 Compile Code
After create a new code or edit the code, if you want to know the code is valid or not , in
the edit interface, press
【
F1
】
,you can compile code to check whether the code is correct.
6.7 Folder Manager
6.7.1 Select Work Folder
The system supports 10 folders, as the figure 6.1 shows.
Work folder : current work folder’s name.
0-/flash 1-DIR1 2-DIR2 3-DIR3 4-DIR4 5-DIR5 6-DIR6 7-DIR7 8-DIR8 9-DIR9
These 10 symbols interpret 10 folders’ names. The number in the first stands for the short
key, press the corresponding number, switch current work folder into corresponding folder. For
example, press
【
1
】
, it will show as the figure 6.6.
