Service Support Spirit
Unique Solution
WWW.ARCBRO.COM
56
7.1 Common Parameters
It is the favorite’s parameters in Fig7.1.
Cutting Speed: the maximum cutting speed, unit is mm/m.
Manual Move Speed: the moving speed of cutting torch in manual, unit is mm/m.
G00 Move Speed: the cutting torch speed when G00 is executed or the cutting torch go back
to the reference or some other occasion, unit is mm/m.
Kerf: According to the cutting gap width, users set Kerf Gap compensation(the value should be
half of the cutting gap ) to ensure the dimensional precision, the system will generate a new
path automatically to make compensation to work piece. Before cutting a work piece, you can
modify kerf gap value, once begin to cut, you are not permitted to modify the value.
Corner speed: Plate thickness affect the cutting tip’s ac/dc rate when it moving. The angle
between the end of a cut-point line’s tangential direction and the direction of the tangent line of
the beginning of next cutting point, and the thickness of plate determines cutting tip speed at
the transition.
If the normal cutting speed is V, angle is
α
, the proportion of corner speed is h, then
cutting tip speed in at the time of intersection is Vx.
V
h
V
x
π
α
50
=
Notice: The unit is %mm/pm. The max thickness of plate is 100, if more than 100mm
also are considered to be 100.
Cutting Type: There are two cutting types : Oxygen fuel gas and Plasma parameters. You can
press
【←】
or
【→】
to switch with them.
