APPEAR AS
Confidential
250/352
Aspect Ratio
Selects the aspect ratio to be signalled in the output video:
•
16x9
•
4x3
•
1x1
•
Transparent
WSS Blanking
Enables WSS Blanking on the transcoded output
AFD
AFD codes has below options:
•
Pass through: Incoming AFD codes are not applied, but passed
through to video output stream.
•
Apply: Incoming AFD codes are applied to video output stream.
•
Remove: Incoming AFD codes are not applied and removed
from the video output stream.
Picture In Picture
Enable PIP video. This will generate a new selectable service for use
on any of the output modules. Both share the same audio.
PIP Resolution
Sets the resolution of the PIP video.
PIP Video Bitrate
Sets the bit-rate of the PIP video. Range: 250kbps to 1Mbps
The CBR video bit-rate affects only the video PID. An IP output may still be a VBR
transport stream. Some IP receivers require that the IP output is set to CBR mode. This
can be set on the
Port Settings
tab of the output stream
Transcoder PIP is from the default PID values as the Main service whereas Encoder PIP
PID value is configured on the service page.
The PIP service appears on the Input list and can be sent to the output as any other input service.
