APPEAR AS
Confidential
168/352
When double clicking on a input service, you will see a dialog box with information about the
input service. This will show:
•
Service bitrate
•
List the components (show PID,type, language), and show the component rate
Once the output is configured, the system will automatically generate PSI/SI as well as add the service related
PIDs to the output (as configured in
Outputs
→
PSI
). For more information on PSI/SI configuration, refer to
Sections 8.3.4.
If you are unable to drag and drop an input service to an output, there could be a conflict in your
output setup, most likely due to a duplicate ServiceID/Program Number.
For example, if you already have an output service with ServiceID 100, and you attempt to drag
and drop an input service, with ServiceID 100
–
the system will assume that you are trying to
create two output services with the same ID. To get around this, first remap the output service
ID for the existing one. Then, add the new service.
This is only relevant when adding the same ServiceID to an MPTS.
8.1.1
B
ULK
S
ELECTION ON OUTPUT VIEW
8.1.1.1
Configuring SPTS using bulk selection
You can drag a multiple service from the Inputs panel by selecting these using either standard shift key or control
key and drop these on the Output panel as SPTSs. When doing this, you will be presented with the following
dialog box in which you can configure each stream.
