APPEAR AS
Confidential
231/352
Parameters for the encoder port can be edited by clicking on the ‘edit’ link associ
ated with each port.
In order to activate the port, the ‘Enable’ checkbox must be selected and the setting applied by clicking on the
‘Apply’ button.
9.2.1
H
ARDWARE
C
ONFIGURATION
(EC-400)
Depending on the mode of the hardware, it will be possible to configure the internal transcoder blocks (A, B, C
and D) to different input/output resolutions, eg HD, SD, HD+PIP, SD+PIP. The overview and configuration of this
is on the
Setup Hardware
page under the
Coders
tab in the Navigation Pane:
In order to change the mode of the block, select the correct option from the pull-
down menu and click the ‘Apply’
button.
Re-configuring a block with existing channels will cause this block to be de-configured and
the services removed from the output configuration.
9.2.2
S
OURCE
C
ONFIGURATION
9.2.2.1
SDI Encoder (EC-100, EC-200, EC-400)
Once SDI signals are connected to their respective input ports, the source parameters can be set on the
Source
tab on the encoder ‘edit’ dialog. Available parameters are:
Frame Rate
Frame rate of the incoming signal.
