Enter 114 End
*/$%ENTR* *ZEND*
Setting up your Operation Modes
7
7-2-2-3.
Set Small Trigger Functionality
Small Trigger is designed to perform various supplementary operations, from initiating
battery charge to switching to data transmission mode, according to the length of time the
button has been pressed. To facilitate the associated operations with Small Trigger, this
parameter is available to specify the degree of Small Trigger’s functionality. Scan
Disable
label to specify Small Trigger will not provide any additional function. On the other hand,
when
Mem Tx
is enabled, the device is able to switch to data transmission mode by
keeping holding Small Trigger long enough to trigger off a solid green LED light.
7-2-2-4.
Set Composite Triggers Functionality
Some supplementary functions are necessarily executed by using composite triggers
though Scan Button primarily serves to scan barcodes and Small Trigger to initiate data
transmission. In Cable mode, battery charge is an extra function which can be initiated by
pressing Small Trigger and Scan Button in a specified sequence described below: while
holding Small Trigger till the green LED light starts flashing rapidly, press down Scan
Button at the same time and then release both buttons. Scan the appropriate label to
enable or disable functionality of battery charge.
*B81D2*
USBSpp
B81D2
*B81D3*
Spp
B81D3
*B8290*
Disable
B8290
*B8292*
Mem Tx
B8292
*B8280*
Disable
B8280
*B8281*
ChgSw
B8281
