Altigen AltiWare OE/ACC Version 5.0, Administration Manual

Page: 260 / 470

Incoming Call Routing
7-20 AltiWare OE System Installation & Administration Manual
Caller ID and DID Incoming Sequence Example
The following is an example of a Caller ID and DID/DNIS incoming
sequence window.
Figure 8. Incoming Sequence window
When a call comes in, the system tries to match the incoming sequence to
either the first or second Incoming Sequence Digit String sequence. If no
match is found, no Caller ID or DID digits will be collected.
• The system waits 3 seconds for the first digit to arrive. If the symbol is
a
# , it continues with the first sequence. Otherwise, it looks for a match
to the first (and only) symbol in the second sequence, the DID/DNIS
number.
• For the example, let’s say the system receives the # . It then waits 1
second between each digit for the next digit until all digits are received.
The
* symbol is a delimiter between Caller ID and DID digits.
In this example, the AltiServ system is expecting either the sequence
#CID*DID or only DID digits for incoming calls. If no match is found for
either sequence, no Caller ID or DID digits are collected.
Incoming Call Routing
To set incoming call routing for a trunk, select the trunk in the General
window, then click the In Call Routing tab in the Trunk Configuration
window to display the In Call Routing window. The trunk location
appears in the title bar.