ALLIANCE ST3LXFSP401NW22, Programming Manual

Page: 31 / 102

© Published by permission of the copyright owner – DO NOT COPY or TRANSMIT
Programming Control
29
802953
5. Start Pulse Mode “PLSn”
This option allows the owner to program the Start
Pulse Input. The Start Pulse Mode can be used for
after-market central pay or card systems. The central
system sends the start pulse to the Start Pulse Input of
the control to start the cycle. If set for single pulse, one
start pulse from the central system will start the cycle.
If set for multiple pulses, each pulse will deduct from
the vend price value set up in option 4 (Start Pulse
Value) until the vend is satisfied.
How to Program Start Pulse Mode
1. Control must be in Manual Mode. Refer to
Entering the Manual Mode .
2. Press the NORMAL 40 ( ) or the DELICATES
COLD ( ) keypad until “ Prog ” appears in the
display. Press the START (enter) keypad and
“ AtS1 ” will appear in the display.
3. Press the NORMAL 40 ( ) or the DELICATES
COLD ( ) keypad to scroll through the
programmable options until “ PLSn ” appears in
the display.
4. When “ PLSn ” appears in the display, press the
START (enter) keypad. “ oFF ” or a number will
appear in the display. This number corresponds to
the current Start Pulse Mode Programming
Value.
5. Locate the desired number in the first column of
Table 1 below.
6. Press the NORMAL 40 ( ) or the DELICATES
COLD ( ) keypad to increase or decrease the
current number until correct.
NOTE: To go back to the current programmable
option without changing the current value, press
the DELICATES 30 (<) keypad.
7. Press the START (enter) keypad when the correct
number appears in the display. The next option,
“ AtyP ”, will appear in the display.
NOTE: To program “ AtyP ” (Available Type), refer
to option 6 . To program other options, refer to the
appropriate section.
How to Exit Programming Feature
Press the DELICATES 30 (<) keypad until the control
returns to Ready Mode.
>
<
>
<
“PLSn”
Start Pulse
Mode Value
Start Pulse
ON/OFF
Single Pulse/
Multiple Pulses
“
oFF
”* OFF OFF
128 ON Single Pulse
192 ON Multiple Pulses
*Factory default setting.
Table 1
>
<