ALLIANCE ST3LXFSP401NW22, Programming Manual

Page: 85 / 102

© Published by permission of the copyright owner – DO NOT COPY or TRANSMIT
83
802953
Collecting Audit Information
This feature allows the owner to retrieve audit
information stored in the washer by pressing a sequence
of pads on the control. For an explanation of the audit
options available, refer to Table 14 .
How to Enter Audit Feature
There are two methods the owner can use to enter the
Audit Feature.
Entering the Audit Feature by Manual
Mode
1. Control must be in Manual Mode to start. Refer
to Entering the Manual Mode .
2. Press the NORMAL 40 ( ) or the DELICATES
COLD ( ) keypad until “ AUdt ” appears. Refer to
Figure 27 .
Figure 27
3. Press the START (enter) keypad. “ CyC ” will
appear.
Entering the Audit Feature with the Coin
Vault Open
1. Open coin vault. Make sure service door is
closed.
2. Press the START (enter) keypad.
How to Read Audit Data
1. Use the NORMAL 40 ( ) or the DELICATES
COLD ( ) keypad to scroll through various
options until the desired option is shown in the
display. Refer to the Audit Options List, Table
14 , for an explanation of the audit options
available.
2. Once the desired option appears in the display,
press the START (enter) keypad once to start the
audit count. At this point, the display will show
the first four-digit segment of the audit value. If
the audit count is 10,000 or higher, press the
START (enter) keypad again to view the last four
digits of the number.
NOTE: The display can show up to 4 digits at one
time. Audit counts 10,000 or higher are separated
into two 4-digit segments. Each time the START
(enter) keypad is pressed in step 2, the display will
show the next 4-digit segment in the audit value. If
the value is 9,999 or less, only one 4-digit segment
will be shown.
For Example: In the Total Number of Coins #1 option
with “ CoI1 ” shown in the display, the audit has
counted 10,009 coins. Pressing the START (enter)
keypad one time will show “ _ _ _ 1 ” to represent ten
thousand. Pressing the START (enter) keypad a second
time will display “ 0009 ” meaning nine. The total
equals “ 00010009 ” or 10,009.
3. Press the START (enter) keypad again. The
control will go to the next audit option in the
Audit Options List.
4. To select other audit options, repeat steps 1 – 4.
How to Exit Audit Feature
Press the DELICATES 30 (<) keypad until the control
returns to Ready Mode.
NOTE: To exit Audit Feature when using Coin
Vault Open method, owner must close coin vault.
The control will then return to Ready Mode.
CHM511R
>
<
>
<
Audit Options List
# Display Description
1
“
CyC
”
Total # of machine cycles
2
“
CoI1
”
Total # of coins #1
3
“
CoI2
”
Total # of coins #2
4
“
PLSE
”
Total # of Start Pulses
Table 14