ALLIANCE ST3LXFSP401NW22, Programming Manual

Page: 74 / 102

Programming Control
802953 72 © Published by permission of the copyright owner – DO NOT COPY or TRANSMIT
How to Program Default Cycle Modifier
“CnP6” (software version “S 02” or higher
only)
This option allows the owner to set the Default Cycle
Modifier.
1. Press the NORMAL 40 ( ) or the DELICATES
COLD ( ) keypad to scroll through the
programmable Cycle Modifier options until
“ CnP6 ” appears in the display.
2. When “ CnP6 ” appears in the display, press the
START (enter) keypad. A number will appear in
the display. This number corresponds to the
current default cycle modifier. Refer to Table 12 .
3. Press the NORMAL 40 ( ) or the DELICATES
COLD ( ) keypad to increase or decrease the
current number to the desired number selected
from Table 12 .
4. Press the START (enter) keypad when the
desired number appears in the display. The next
Cycle Modifier option, “ CnP1 ”, will appear in
the display.
NOTE: To program “PCt-” (Cycle Time Display),
press the DELICATES 30 (<) keypad and refer to
option 24 . To program other options, press the
DELICATES 30 (<) keypad and refer to the
appropriate section.
How to Exit Programming Feature
Press the DELICATES 30 (<) keypad until the control
returns to Ready Mode.
>
<
>
<
“CnP6”
Default Value Cycle Modifier
0* A
1 B
2 C
*Factory default setting.
Table 12