802953
14
© Published by permission of the copyright owner – DO NOT COPY or TRANSMIT
Entering the Manual Mode
For programming, testing, and retrieving information
from the control, it is often necessary to enter the
Manual Mode by following the four simple steps below.
For an overview of entering the Manual Mode, refer to
the flowchart on the following page.
How to Enter the Manual Mode
1. If accessing Diagnostic Tests, be sure the washer
is in the Ready Mode before continuing to step 2.
If the washer is in an active cycle, rapid advance
through the cycle. Refer to the
Rapid Advance
Feature
. If coins or a card has been entered, refer
to
Clear Vend Feature
.
2. Open the service door. Refer to
Opening the
Service Door
.
NOTE: The coin vault switch must be closed to
enter Manual Mode.
3. While pressing and holding the NORMAL 90
keypad with one hand, press the PERM
PRESS 60 keypad with the other hand.
4. The display will show “
rAPd
”
.
5. Press the NORMAL 40 ( ) or the DELICATES
COLD ( ) keypad to scroll through the options
until the desired option appears in the display.
6. Press the START (enter) keypad.
NOTE: After entering Manual Mode, if no keypads
are pressed for 4.25 minutes, the control will return
to the previous mode of operation.
7. To exit, press the DELICATES 30 (
<
) keypad.
The control will revert back to Ready Mode.
Manual Mode is broken into three groups: Manual
Programming, Manual Rapid Advance and Manual
Diagnostics. Manual Programming can only be turned
on or off with an external device or the network. Refer
to the appropriate instruction manual. Manual Rapid
Advance and Manual Diagnostics can be turned on and
off using an external device, by manual programming
(refer to
options 32
and
33
of
Programming Control
),
or with the network.
By default, all groups are turned “
on
”.
The manual features available in each group are as
follows (the menu shown on the display in this mode
is in parentheses).
Manual Programming
Manual Programming
(Prog)
Manual Read Audit
(AUdt)
Manual Reset
(rSEt)
Manual Rapid Advance
Rapid Advance
(rAPd)
Manual Diagnostics
Manual Diagnostic Tests
(dIAg)
If a group is turned off, the display will change from
the selected feature to “
oFF
” when the START (enter)
pad is pressed. An audio signal will then sound for one
(1) second and the display will return to the selected
feature. The features in the group cannot be entered.
>
<
Summary of Contents for ST3LXFSP401NW22
Page 2: ......
