ALLIANCE ST3LXFSP401NW22, Programming Manual

Page: 30 / 102

Programming Control
802953 28 © Published by permission of the copyright owner – DO NOT COPY or TRANSMIT
4. Start Pulse Value “PLSE”
This option allows the owner to program the value of
the Start Pulse if used for multiple pulses with an after-
market central card reader or pay system. Refer to
option 5 for additional information.
How to Program Start Pulse Value
1. Control must be in Manual Mode. Refer to
Entering the Manual Mode .
2. Press the NORMAL 40 ( ) or the DELICATES
COLD ( ) keypad until “ Prog ” appears in the
display. Press the START (enter) keypad and
“ AtS1 ” will appear in the display.
3. Press the NORMAL 40 ( ) or the DELICATES
COLD ( ) keypad to scroll through the
programmable options until “ PLSE ” appears in
the display.
4. When “ PLSE ” appears in the display, press the
START (enter) keypad. There are five digits in
the Start Pulse Value. The fifth digit will appear
in the display and will flash one second on and
one second off. Refer to Figure 13 .
NOTE: If the Start Pulse Value is 10000 or more,
the fifth digit is “ 1-6 ”. If the Start Pulse Value is
9999 or less, the fifth digit is “ 0 ”.
Figure 13
5. Press the NORMAL 40 ( ) or the DELICATES
COLD ( ) keypad to increase or decrease the
value of the fifth digit.
NOTE: The Start Pulse Value can be set from 1 to
65,535. The factory default setting is 25.
6. Press the START (enter) keypad to enter the fifth
digit and display remaining four digits. The
active digit will flash one second on and one
second off.
NOTE: To go back to the current programmable
option without changing the value, press the
DELICATES 30 (<) keypad.
7. Press the NORMAL 40 ( ) or the DELICATES
COLD ( ) keypad to increase or decrease the
value of the active digit and the START (enter)
keypad to enter the value of the digit and advance
to the next digit.
8. Press the START (enter) keypad with the last
active digit. The next option, “ PLSn ”, will
appear in the display.
NOTE: To program “PLSn” (Start Pulse Mode),
refer to option 5 . To program other options, refer to
the appropriate section.
How to Exit Programming Feature
Press the DELICATES 30 (<) keypad until the control
returns to Ready Mode.
CHM507R
>
<
>
<
>
<
>
<