ALLIANCE ST3LXFSP401NW22, Programming Manual

Page: 11 / 102

© Published by permission of the copyright owner – DO NOT COPY or TRANSMIT
9
802953
Washer Operation
Start Up
When power is applied to the washer, the control will
display its software version as “ S XX ” (“ XX ” is the
version number) for one (1) second. If the control was
not powered down during a running cycle, it will enter
the Ready Mode.
Ready Mode
In this mode of operation, the display shows the
current selected cycle, temperature and soil level, and
the full current vend price for that cycle. The INSERT
COINS/CARD LED is lit.
To start the cycle, the user must satisfy the vend price
and then press the START keypad.
The user will be able to select a different cycle/wash
water temperature or soil level by pressing a cycle pad
when the machine is in the ready mode or in the first
fill step.
Partial Vend Mode
The control enters this mode when part of the vend
price has been entered, but not enough vend is entered
to satisfy the vend price. The control will display the
remaining vend price needed to start the cycle and the
INSERT COINS/CARD LED will be lit.
Additional Vend Mode
The control enters this mode if the first fill was
interrupted to change a cycle/temperature or soil level
that requires more money. If the vend price is not
satisfied within one (1) minute, the washer control will
go back to the first selection and the cycle will
continue. After the first fill, all key presses will be
ignored, allowing the washer to go through the
complete cycle.
Start Mode
The control enters this mode when the full vend price
is satisfied, the vend price is zero or the control is in
OPL Mode. The START pad LED will flash one (1)
second on and one (1) second off. If Start Mode is
entered because the vend price is satisfied or the
control is in OPL Mode, the display will show
“ PUSH ” for one (1) second, “ Strt ” for one (1) second
and the current cycle time for one (1) second. If Start
Mode is entered because the vend price is zero (0), the
display will show “ FREE ”. When first entering Start
Mode, a signal will sound for one (1) second on and
one (1) second off for 10 seconds if signal for Start is
enabled.
After pressing the START keypad, the door will lock
and the cycle will begin.
End of Cycle Mode
When a cycle is complete, the control will display “ 00 ”
until the washer door is opened, a key is pressed, or a
coin/card is entered. When one of these three options
occurs, the display will revert back to the ready mode.
Cycle Sequence
Upon the start of a cycle, the control will display the
total cycle time. The appropriate LEDs will light while
the machine passes through different cycle steps. Any
coin entered after the first fill cycle will be added to
the total coin counter, but the user will not be able to
change cycles.
Closing Washer Door
If the door is not closed when the vend price is satisfied,
“ door ” will be displayed until the door is closed. Once
door is closed, the START pad must be pressed to lock
door and start the cycle. If the door does not lock within
15 seconds of being closed, “ E dL ” will be displayed,
indicating a door lock error, while the door continues to
try to lock.
If the door locks after 15 seconds, the door lock error
will clear and the cycle will continue normally.