© Published by permission of the copyright owner – DO NOT COPY or TRANSMIT
13
802953
Opening the Service Door
Coin and Card Reader Units
Manual programming requires the user to open and
close the service door. Opening and closing the service
door trips a switch allowing access to various
programming options, diagnostics, and audit
capabilities.
The service door is located in the control panel. Refer
to
Figure 2
.
After opening and closing the service door, the
programmer has 4.25 minutes to begin programming.
If a keypad has not been pressed in that time, the
control will revert back to the Ready Mode. Refer to
Figure 2
.
NOTE: If the Break-In Alarm option is enabled, it
must be turned off or disabled by pressing the two
programmed keys before opening service door. For
more information on using the Break-In Alarm,
refer to the external device or network software
instructions.
Units Prepped for Central Pay System
Manual programming requires the user to remove the
control panel and unplug the bullet connector located
between the “white/black” and “red/blue” wires. This
will allow the user to access various programming
options, diagnostics, and audit capabilities. Refer to
Figure 2
.
Figure 2
1
Service Door
2
Control Panel
FLW31R
F
DRY2074N
1
1
Coin/Card Stacked Washer and Dryer
FLW31R
Central Pay Washer
DRY2074N
2
Coin/Card Front Control Washer
SWD699N
2
FLW32R
SWD699R
Central Pay Stacked Washer and Dryer
Summary of Contents for ST3LXFSP401NW22
Page 2: ......
