Agilent Technologies InfiniiVision 3000 X-Series, Programmer'S Manual

Page: 47 / 1232

Setting Up
2
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 47
Step 2. Connect and set up the oscilloscope
The 3000 X- Series oscilloscope has three different interfaces you can use
for programming:
• USB (device port).
• LAN, when the LAN/VGA option module is installed. To configure the
LAN interface, press the
[Utility]
key on the front panel, then press the
I/O softkey, then press the Configure softkey.
• GPIB, when the GPIB option module is installed.
When installed, these interfaces are always active.
Using the USB (Device) Interface
1 Connect a USB cable from the controller PC's USB port to the "USB
DEVICE" port on the back of the oscilloscope.
This is a USB 2.0 high- speed port.
Using the LAN Interface
1
If the controller PC is not already connected to the local area network
(LAN), do that first.
2 Contact your network administrator about adding the oscilloscope to
the network.
Find out if automatic configuration via DHCP or AutoIP can be used.
Also, find out whether your network supports Dynamic DNS or
Multicast DNS.
Figure 1 Control Connectors on Rear Panel
USB Device Port
LAN/VGA
Option Module
GPIB
Option Module