Agilent Technologies InfiniiVision 3000 X-Series, Programmer'S Manual

Page: 44 / 1232

44 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
1
What's New
Obsolete
Commands
Discontinued
Commands
:WAVeform:SOURce (see
page 945 )
Can select reference waveforms as the source.
:VIEW (see page 217 ) PMEMory (pixel memory) locations are not present.
Command Differences From InfiniiVision 7000B Series Oscilloscopes
Obsolete Command Current Command Equivalent Behavior Differences
Command Description
:ACQuire:RSIGnal The 3000 X-Series oscilloscope does not have a 10 MHz REF
BNC connector.
:CALibrate:SWITch? Replaced by :CALibrate:PROTected? (see page 248 ). The
oscilloscope has a protection button instead of a switch.
:DISPlay:SOURce PMEMory (pixel memory) locations are not present.
:EXTernal:IMPedance External TRIG IN connector is now fixed at 1 MOhm.
:EXTernal:PROBe:ID Not supported on external TRIG IN connector.
:EXTernal:PROBe:STYPe Not supported on external TRIG IN connector.
:EXTernal:PROTection Not supported on external TRIG IN connector.
:HARDcopy:DEVice,
:HARDcopy:FORMat Use the :SAVE:IMAGe:FORMat, :SAVE:WAVeform:FORMat, and
:HARDcopy:APRinter commands instead.
:MERGe Waveform traces have been replaced by reference waveforms.
:RECall:IMAGe[:STARt] Waveform traces have been replaced by reference waveforms.
:SYSTem:PRECision The 3000 X-Series oscilloscopes' measurement record is 62,500
points, and there is no need for a special precision mode.
:TIMebase:REFClock The 3000 X-Series oscilloscope does not have a 10 MHz REF
BNC connector.