ABB ACS880 N5700 Series, Firmware Manual, Page: 337 / 662

Def / Type
FbEq 16b / 32b Description Name / Range /
Selection No.
14 A883 Power ups . Counted power ups
15 A885 DC charge . Counted DC charges
0 / real32 Displays the actual present value of value counter 1.
The value of the source selected by parameter
33.53
Value counter 1 source is read at one-second intervals
and added to the counter. A divisor can be applied to
the count (see
33.54 Value counter 1 divider ).
When the counter exceeds the limit set by 33.51 Value
counter 1 warn limit , bit 4 of 33.1 Counter status is set
to 1.
The warning specified by
33.55 Value counter 1 warn
message is also given if enabled by 33.52 Value counter
1 function .
The counter can be reset from the Drive Composer PC
tool, or from the control panel by keeping Reset
depressed for over 3 seconds.
Value counter 1
actual 33.50
- / - Actual present value of value counter 1. -2147483000...2147483000
- / real32 Sets the limit for value counter 1.
With a positive limit, bit 4 of
33.1 Counter status is set
to 1 (and a warning optionally generated) when the
counter is equal or greater than the limit.
With a negative limit, bit 4 of
33.1 Counter status is set
to 1 (and a warning optionally generated) when the
counter is equal or smaller than the limit.
0 = Counter disabled.
Value counter 1 warn
limit 33.51
- / - Limit for value counter 1. -2147483000...2147483000
- / uint16 Configures value counter 1. Value counter 1
function 33.52
0 = Loop: When the limit is reached, the counter is reset.
The counter status (bit 4 of
33.1 ) switches to 1 for one
second. The warning (if enabled) stays active for at
least 10 seconds.
1 = Saturate: When the limit is reached, the counter
status (bit 4 of
33.1 ) switches to 1, and remains so until
33.50 is reset. The warning (if enabled) also stays active
until 33.50 is reset.
Counter mode b0
0 = Disable: No warning is given when the limit is
reached
1 = Enable: A warning (see
33.55 ) is given when the limit
is reached
Warning enable b1
Reserved b2…15
1 = 1 0000h…FFFFh
Not selected / uint32 Selects the signal to be monitored by value counter 1. Value counter 1
source 33.53
0 None (counter disabled). Not selected
1 1.1 Motor speed used . Motor speed
See Terms and abbreviations (page 130) . Other [bit]
Parameters 337