ABB ACS880+N5350, User Manual

Page: 14 / 247

Product Familiarization 2-3 3AXD50000011888
2.4.2 Control Panel
The control panel can be removed by pulling it forward from the top edge and reinstalled in reverse order. For the use of the
control panel, see the firmware manual or ACS-AP assistant control panels user’s manual (3AUA0000085685 [English]).
Figure 2-2
2.5 Connections
The connections of the N5350 are segmented into the two groups classified as Power Connections and Control
Connections. Conduit mounting holes are provided on the enclosure for each group of connections. See Appendix B for
conduit hole sizes so that proper planning can be accomplished for routing conduits to the control.
Access to all connections can be gained by the removal of the front cover.
WARNING: Do not remove the control cover for at least five (5) minutes after AC power is disconnected to
allow capacitors to discharge. Dangerous voltages are present inside the equipment. Electrical
shock can cause serious or fatal injury.
The power connections are grouped separately from the control connections and may be separated by a protective plate
depending on the size of the control. The installer must maintain separation between power connections and control
connections so that electrical noise does not interfere with proper operation. This dictates separate conduits for each group
of wires. See subsequent sections on power and control wiring for details of the required connections.