3Com V6100, User Manual Manual, Page: 472 / 496

472
V6100 and V7122 User Guide
ƒ
Stop Bits = 1
ƒ
Flow Control = None
5
Insert the “Boot CD” (created in Stage 3) into the USB CD-ROM.
6
Power up the V6100.
7
On the Terminal screen, the BIOS phase will start and the Linux
TM
installation will begin.
The installation will uncompress the kernel, load it and its drivers and start the interactive
installation.
After the BIOS phase, some badly formatted text may appear on the screen.
From this point on, you should proceed with the screen instructions, as instructed
by your Linux distributor.
Additional Linux™ Debian Installation Notes (14)
Please see the following notes for the remaining part of the installation.
1
The first interactive screen should be “Language Selection”. Before you select the
language you wish to use, remove the “Boot CD” and insert the 1st Debian installation
disk. Select the language you wish to use.
2 As you continue with the installation, you should go through the following stages of the
installation:
a) Country selection
b) CROM scan
c)
DHCP configuring
3
Configure your network settings manually by selecting the “ Configure network
manually ” option. Either:
ƒ
the DHCP configuration will fail and a screen enabling you to configure the network
manually will appear,
or
ƒ
go to the Main Installation menu and select the manual network configuration.
Ensure the network is connected and set a
Static IP Address and all the other
network parameters.
4
Continue with the installation, going through the following screens:
ƒ
“Partition disks”
ƒ
“Installing the Debian base system”
5
At the “ Install the GRUB boot loader on hard disk ” screen, select “ Go Back ”. This
returns you to “ Debian installer main menu ” screen. This is the main menu of the
installation.