3Com V6100, User Manual Manual, Page: 363 / 496

V6100 and V7122 User Guide
363
The following are special notes pertaining to MIBs:
•
A detailed explanation of each parameter can be viewed in an SNMP browser
in the ‘MIB Description’ field.
•
Not all groups in the MIB are functional. See version release notes.
•
Certain parameters are non-functional. Their MIB status is marked 'obsolete'.
•
When a parameter is set to a new value via SNMP, the change may affect
device functionality immediately or may require that the device be soft reset
for the change to take effect. This depends on the parameter type.
The current (updated) device configuration parameters are programmed into the
device provided that the user does not load an
ini file to the device after reset.
Loading an ini file after reset overrides the updated parameters.
Additional MIBs are to be supported in future releases.
Traps
As of this version all traps are sent from the SNMP port (default 161). This is part
of the NAT traversal solution.
Full proprietary trap definitions and trap Varbinds are found in the acBoard MIB and acAlarm
MIB.
The following proprietary traps are supported. For detailed information on these traps, see
Appendix
1
F: SNMP Traps :
ƒ
acBoardFatalError - Sent whenever a fatal device error occurs.
ƒ
acBoardConfigurationError - Sent when a device’s settings are illegal - the trap contains
a message stating/detailing/explaining the illegality of the setting.
ƒ
acBoardTemperatureAlarm - Sent when a board exceeds its temperature limits (doesn’t
apply to the TP-260 board).
ƒ
acBoardEvResettingBoard - Sent after the device is reset.
ƒ
acBoardEvBoardStarted - Sent after the device is successfully restored and initialized
following reset.
ƒ
acFeatureKeyError - Development pending. Intended to relay Feature Key errors, etc.
ƒ
acBoardCallResourcesAlarm - Indicates that no free channels are available.
ƒ
acBoardControllerFailureAlarm - The Gatekeeper/Proxy is not found or registration
failed. Internal routing table can be used for routing.
ƒ
acBoardOverloadAlarm - Overload in one or some of the system's components.