3Com V6100, User Manual Manual, Page: 371 / 496

V6100 and V7122 User Guide
371
Using the acBoard MIB:
The following parameters (that are defined in the snmpManagersTable) are available:
ƒ
snmpTrapManagerSending
ƒ
snmpManagerIsUsed
ƒ
snmpManagerTrapPort
ƒ
snmpManagerIP
When snmpManagerIsUsed is set to zero (not used), the other three parameters are set to
zero as well. The intention is to have them set to the default value, which means TrapPort is
set to 162. This is to be revised in a later release.
ƒ
snmpManagerIsUsed (Default = Disable(0))
The allowed values are 0 (disable or no) and 1 (enable or yes).
ƒ
snmpManagerIp (Default = 0.0.0.0)
This is known as SNMPManagerTableIP in the
ini file and is the IP address of the
manager.
ƒ
SnmpManagerTrapPort (Default = 162)
The valid port range for this is 100-4000.
ƒ
snmpManagerTrapSendingEnable (Default = Enable(1))
The allowed values are 0 (disable) and 1 (enable).
Each of these MIB objects is independent and can be set regardless of the state
of snmpManagerIsUsed.
If the parameter IsUsed is set to 1, the IP address for that row should be supplied
in the same SNMP PDU.
Using the SNMPTargetMIB:
To add a trap destination:
ƒ
Add a row to the snmpTargetAddrTable with these values:
Name=trapN, TagList=AC_TRAP, Params=v2cparams, where N is an unused number
between 0 and 4.
All changes to the trap destination configuration take effect immediately.
To delete a trap destination:
ƒ
Remove the appropriate row from the snmpTargetAddrTable.