A - 7
Informazioni importanti per la sicurezza
AVVERTENZA:
il testo delle avvertenze riporta importanti istruzioni alle
quali occorre attenersi per motivi di sicurezza. Seguire attentamente tutte
le istruzioni.
Prima di installare l'unità, leggere attentamente le informazioni riportate
di seguito.
■
Procedere con estrema cautela durante l'installazione e la rimozione
dell'unità.
■
Collocare l'unità vicino a una presa di corrente e verificare che la presa
sia accessibile.
■
Per garantire la conformità alle norme di sicurezza nazionali e
internazionali, usare l'adattatore di corrente fornito con l'unità. Se
l'adattatore non è compreso, il cavo alimentatore deve essere
conforme alle norme locali e nazionali del paese di destinazione
nonché all'omologazione di sicurezza del prodotto (per ulteriori
informazioni consultare la sezione relativa alle omologazioni riportata
alla fine del manuale).
■
Scollegare l'adattatore prima di spostare l'unità. Per scollegare l'unità
occorre rimuovere l'adattatore dall'unità stessa o dalla presa di
corrente.
■
Collegare alle porte dell'unità solamente apparecchi conformi ai
requisiti della relativa interfaccia. Le specifiche riguardanti la sicurezza
delle porte sono le seguenti:
■
Porte contrassegnate dalle targhette XXXX e YYYY = TNV. TNV
(Telecoms Network Voltage) è un circuito che, in normali
condizioni di esercizio, trasmette segnali di telecomunicazione.
■
Porte contrassegnate dalle targhette AAAA e BBBB = SELV. SELV
(Safety Extra Low Voltage) è un circuito secondario ideato e
protetto in modo tale che, in condizioni normali e in caso di un
unico guasto, la tensione tra due parti accessibili qualsiasi non
superi il valore di sicurezza (42,2 V picco o 60 V CC).
■
All'interno dell'unità non vi sono fusibili sostituibili dall'utente o parti
la cui manutenzione può essere effettuata dall'utente. Se si verifica un
problema che non si è in grado di risolvere seguendo le istruzioni per
la risoluzione dei problemi riportate nel presente manuale, contattare
il rivenditore 3Com presso il quale si è acquistata l'unità.
■
Se le unità sono impilabili, impilare solamente unità simili.
■
Solo per ServiceConnect: collegare il filo di massa di sicurezza in
posizione centrale sulla base dell'unità rack ServiceConnect 2000.
Summary of Contents for OCG VOICE EXPANSION -
