background image

Ubee Interactive — www.ubeeinteractive.com 

 

 

 

  Ubee DDW366 – Safety and Installation Product Insert v1.0 

DDW366 Advanced Wireless Gateway - 
Safety and Installation Product Insert 

 

Federal Communications Commission 
(FCC) Interference Statement

 

This device has been tested and found to comply 
with  the  limits  for  a  Class  B  digital  device, 
pursuant  to  Part  15  of  the  FCC  Rules.  These 
limits  are  designed  to  provide  reasonable 
protection  against  harmful  interference  in  a 
residential  installation.  This  device  generates, 
uses, and can radiate radio frequency energy. If 
not  installed  and  used  in  accordance  with  the 
instructions,  the  device  may  cause  harmful 
interference  to  radio  communications.  There  is 
no guarantee, however, that interference will not 
occur  in  a  particular  installation.  If  the  DEVICE 
causes harmful interference to radio or television 
reception, which can be determined by turning it 
off  and  on,  the  user  can  try  to  correct  the 
interference by one of the following measures: 

  Increase the separation between the DEVICE 

and the equipment with which it is interfering 
(for example, a television or radio). 

  Connect  the  DEVICE  into  an  electrical  outlet 

on a different circuit than the interfered device 
is connected. 

  Consult the dealer or an experienced radio/TV 

technician for help. 

 

FCC Regulatory Information 

This  device  complies  with  Part  15  of  the  FCC 
Rules.  Operation  is  subject  to  the  following  two 
conditions:  (1)  This  device  may  not  cause 
harmful  interference,  and  (2)  this  device  must 
accept  any  interference  received,  including 
interference that may cause undesired operation. 

There is one statement for this product:   

  Only the type of PIFA antenna tested may be 

used. 

Summary of Contents for DDW366








Reviews: