Zero88 ILLUSION 500, Руководство по эксплуатации

Страница: 17 / 122

Quickstart Tutorial
Introduction
This chapter enables you to get the
desk up and running quickly and set
up, program and playback a simple
show.
It starts by covering how to turn the
desk on and set up the required
dimmer channels and fixtures
(assignment and DMX patching).
It then covers how to set up dimmer
channel and fixture data on the
outputs, save the data into memories
or submasters, and transfer memories
onto submasters.
It then continues with playing back the
memories using the Playback X
controls, and outputting data from
submasters.
Finally, it gives a summary of how
memories can also be edited and
played back from the Cueline screen.
Before starting a new lighting session it
may be necessary to clear an existing
show or reset the desk. If so, refer to
chapter 10 for details.
This tutorial assumes that a suitable
lighting rig has already been set up
with dimmers, luminaires, scrollers or
moving lights (as required) which are
controlled by a standard DMX signal.
Turning on the Desk
Connect the DMX output cable,
monitor, keyboard and mouse to the
desk.
Connect the power supply to the desk
and monitor and switch on at the
mains.
Desk Setup
The default setup for the desk is 120
dimmer channels patched 1:1 with the
DMX outputs.
If your lighting rig has a different
number of dimmer channels (more or
less) and intelligent moving light
fixtures or scrollers, then these need to
be assigned and patched to the DMX.
See the Desk Setup section in Chapter
three for full details.
Preparing to Plot
Ensure that Blackout is not active (red
light in the BLACKOUT button is off ).
Set the Playback X MASTER and
GRAND MASTER faders to full and all
the SUBMASTER faders to zero.
Press the SCREEN FUNCTION
BUTTON F2 to display the Memories
screen on the monitor.
Illusion 500 Manual 73-741-00 Issue 2 2 - 1
Figure 2 - 1: The Illusion 500 Lighting Desk
For news, views and latest software
visit our dedicated Illusion website at:
www.illusionsupport.com