Westomatic H2O Hydration Station Azure Mk4, Техническое руководство

Страница: 59 / 125

Part Number: 350092 Issue: 3
Page 59 of 125
© Copyright Westomatic Vending Services Limited 2020
All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted, in any form or by
any means, electrical, mechanical, photocopying, recording or otherwise, without prior permission from Westomatic Vending
Services Limited.
13.2.5 ► Pin Codes Set-up
Pin code Setup
└―――――► Service pins
└―――――► Access Level 3
└―――――► Access Level 4
└―――――► Reset service pins
This will allow the user to set the service access pin codes. The hydration station has a level 3
and a level 4 pass code for service engineers to access the machine. Each pass code has a
different level of access to the machine settings. A pass code of a higher service level can
change the access codes of a lower level.
‘Service Pins’ are reached via ‘Service Mode’ thus:
►
SERVICE MODE <Enter 4-digit access code>
└ ► MACHINE SETTINGS
└ ►PIN CODES SETUP
13.2.5.1 Access Level pin

When in ‘Pin codes setup’ press button 3L to enter the Service pins sub menu. Use buttons
1 or 2 to scroll through the available ‘Access levels’. An ‘Access level’ can be enabled by
selecting it and pressing button 3L to accept. Once enabled, the chosen ‘Access level’ will
flash ????. From this menu you now use the four push buttons as an access code. The
buttons are numbered from left to right as 1 2 3 4.

Enter your new access code on the screen.

After the fourth digit has been entered you have to accept the change by pressing 3L .

If you enter the Access level pass code by mistake it will be necessary to press button 3S
five times. This will enter the number 3333 on the screen followed by the cancel command
3S .

Press cancel 3S to exit back into ‘Door Open Mode’ to ensure the new settings are saved
to the machine VMC.
13.2.5.2 Reset service pins
When in ‘Pin codes setup’ press button 3L to enter the Service pins sub menu. Use buttons 1
or 2 to scroll to Reset Service Pins and press 3L to accept. The VMC will reset the access level
codes for levels 3 and 4 to their original default settings.
13.2.6 ► Diagnostics
Diagnostics
└―――――► Display Fault Log
└―――――► Clear Fault Log
└―――――► Reset Audit Log
└―――――► Last drink BTN
└―――――► Last drink code
└―――――► Triac Testing
‘Diagnostics’ are reached via ‘Service Mode’ thus: