Part Number:
350092
Issue: 3
Page 28 of 125
© Copyright Westomatic Vending Services Limited 2020
All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted, in any form or by
any means, electrical, mechanical, photocopying, recording or otherwise, without prior permission from Westomatic Vending
Services Limited.
10.2.2
Flush juice
Open machine door
Place waste bucket on the support hook under the dispense
nozzle as per section 10.2.1
Press and hold each flush button as or if required, these are
located on the rear of the door.
10.2.3
Clean bottle station
Switch off power to the machine.
Position the waste bucket in the correct position on the floor
and close the machine door.
Use warm soapy water to clean the cup station area.
Use a soft dry cloth to dry.
10.2.4
Clean drip tray
Open the machine door
Rotate the two clamps A and B holding the drip tray in place
Pull the drip tray out C
Drip tray can further be dismantled if required by removing the three
black thumb screws on the base.
Remove the drip tray flow guide D and clean in warm soapy water.
Clean and dry all parts and replace in the reverse direction.
10.2.5
Clean front door
Wipe down the front of the door with a sanitising solution and a soft cloth.
Wipe down the media screen and buttons with a glass sanitising solution and a soft cloth.
Clean the inside of the door with warm soapy water paying particular attention to the bottom of the door.
10.2.6
Empty waste bin
After the cleaning routine has been completed it is necessary to empty and clean the waste bucket ready for
use.
After cleaning the machine it is important to :
Replace the waste bin back into the machine.
Replace the brass bell back into the waste bucket.
Switch on the machine.
Check for correct operation.
Flush juice 1,2,3
A
B
C
D
