Westomatic H2O Hydration Station Azure Mk4, Техническое руководство

Страница: 43 / 125

Part Number: 350092 Issue: 3
Page 43 of 125
© Copyright Westomatic Vending Services Limited 2020
All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted, in any form or by
any means, electrical, mechanical, photocopying, recording or otherwise, without prior permission from Westomatic Vending
Services Limited.

Pressing 3L to accept sets the asset number display and stops it flashing.

Press cancel 3S to exit back into ‘Door Open Mode’ to ensure the new settings are saved
to the machine VMC.
13.2.1.9 Serial Number
The machine serial number is unique machine reference number assigned to the VMC of each
machine control board at the time of manufacture at the Westomatic factory. The same serial
number will also be visible on the serial plate located on the inside of the machine.
NOTE: The serial number cannot be erased or modified by users.
The machine serial number will be required when requesting parts covered under the
Westomatic Warranty agreement for the machine.
13.2.1.10 Update Firmware
This function enables the user to upload new firmware onto the machine as would be necessary
if firmware enhancements become available for the machine.

A formatted USB memory stick will be required as described in section 15

Open the machine door.

Insert the formatted USB memory stick into the USB port.

The machine will recognise the insertion of the USB memory stick by beeping twice.

From the ‘GENERAL SETTINGS’ sub-menu select “UPDATE FIRMWARE” and press 3L .

The display will show all available firmware files thus
UPDATE FIRMWARE
►AZURE V 03.05.0012

Use scroll buttons 1 or 2 to pick the appropriate file to load into the machine.

Press enter button 3L to accept the chosen file.

The display will show:
FOUND USB MEMORY
AZURE.FMW
LOADING…XX%*
* Indicates the percentage completion of upload.

The firmware upload will take approximately 60 seconds after which the machine will
automatically re-boot and revert to “Door Open Mode”.
13.2.1.11 Load/Read Config
NOTE:
If it is necessary to change the VMC control board, all audit data and machine
configuration settings will be lost. If it is possible, retrieve audit data and machine
configuration using the USB port before removing the processor board.