Part Number:
350092
Issue: 3
Page 47 of 125
© Copyright Westomatic Vending Services Limited 2020
All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted, in any form or by
any means, electrical, mechanical, photocopying, recording or otherwise, without prior permission from Westomatic Vending
Services Limited.
Load Board Defaults
This function allows the user to load the Westomatic factory default drink throw settings.
Note: Board defaults may not be the same as the machine configuration and may not work on
power up. Loading your own config file may be required.
From the ‘LOAD/READ CONFIG’ sub-menu select “LOAD BOARD DEFAULTS” and press
enter
3L
.
The display will show:
LOAD BOARD DEFAULTS
ACCEPT/CANCEL
Pressing
3L
to accept will cause the display to show:
LOAD BOARD DEFAULTS
ARE YOU SURE?
Pressing
3L
to accept will cause the display to show:
LOAD BOARD DEFAULTS
**BUSY**
Pressing
3L
to accept will load the factory saved board defaults back into the machine.
The machine will automatically re-boot and revert to “Door Open Mode”.
13.2.1.12 Load/Read Audit
All Audit information conforms to EVA-DTS standards.
If it is necessary to change the VMC control board, all audit data and machine settings will be
lost. If it is possible, retrieve audit data and machine configuration using the USB port before
removing the processor board.
Load Into Machine
A formatted USB memory stick will be required as described in
section 15
.
Open the machine door.
Insert the formatted USB memory stick into the USB port.
The machine will recognise the insertion of the USB memory stick by beeping twice.
From the ‘LOAD/READ AUDIT’ sub-menu select “LOAD INTO MACHINE” and press
3L
.
The display will show all available configuration files:
SELECT FILE
►A0000001.TXT
A0000002.TXT
Use buttons
1
or
2
to pick the appropriate file to load into the machine.
Press enter
3L
to accept the chosen file.
The display will show:
