Wacker Neuson 2503, Руководство оператора, Страница: 202 / 280

5-20
OM 25-3503 us – Edition 4.1 * * 2503_3503b530.fm
Maintenance
Steel track (option)
•Place a measuring rod A across the highest points of the track.
•Adjust the correct track tension if the play between the track roller and the
track is not 20 – 25 mm (0.8 - 1 in).
Setting the tracks
Warning! WARNING
Risk of lubricant escaping under high pressure!
Can cause serious injury or death.
• Do not loosen and unscrew the lubricating valve by more than one turn.
• Only the lubricating valve may be loosened.
• Keep your face away from the lubricating valve connection.
➥
Contact a Wacker Neuson service center if this does not reduce track
tension.
NOTICE
Excessive tension of the tracks causes serious damage to the cylinder and the
track.
• Tighten the tracks only up to the prescribed measuring distance
Tightening the tracks
☞
Inject grease with the pump through lubricating valve A
☞
Check the tension is correct by starting the engine, letting it run at idling speed and
slowly performing forward and reverse machine travel and switching it off again
☞
Check the tension of the tracks again
➥
If it is not correct:
☞
Adjust again
☞
Should the track still be slack after injecting more grease, replace the track or the seal
in the cylinder. Contact a Wacker Neuson dealer in this case.
Fig. 285: Checking steel track tension
0.8 – 1 in
20 – 25 mm
A
Fig. 286: Tightening the tracks
A