Veloce 400, Руководство пользователя, Страница: 87 / 160

Chapter 5 - Fuselage
5.16 - Bottom seat assembly Page 82
5.16 Bottom seat assembly
5.16.1 front seats
Cut the front seat back panels from the supplied laminate panel. Take a minimum
3-inch gusset, cut out 12 layers of 4.5 x 4.5” BID for each gusset (there will be 4 gussets
for a total of 48 layers). Laminate 6 layers on the angle bracket, fit the laminate piece (2
internal and 2 external – see figure below) and laminate 6 more layers in the same position
on the piece. allow the cure
Remove the corner and finishing pieces in it. Remove excess material. Its position
is defined by the center of the rigid points of the front seat reinforcement (section 5.5 ).
That is, the center of these flanges are placed perpendicular to the center of the rigid
points. Remembering that the outer part is smaller than the inner part and the angles are
positioned with the flange facing inside the seat.