Veloce 400, Руководство пользователя, Страница: 16 / 160

Chapter 3 -
Wing
3.6 - Fuel tank preparation Page 11
3.6.2 Fuel Vent Lines
Fuel tanks must be vented, allowing the entry or exit of air equivalent to the fuel
flow. The upper rear corner of the outermost rib of the tank bays is the preferred location
for locating this vent. The lines are made of aluminum tube ¼ inch provided in the kit.
Direct this vent line to the wing tip and away from it where the underside of the wing will
be as shown in the figure. Secure this line with the temporarily assembled structural
members of the wing, cut any required location for line placement before gluing.
Once the ribs have been definitively glued, glue this to the tank with a paste of
FLOX.
3.6.3 tank breather
take the tube from ½’’ of the breather, make a hole in the upper posterior corner of
the rib so that it can be glued. Make a dry MICRO paste, place the tube in place flush
with the liner and glue it in place with the paste on both sides of the rib.