Veloce 400, Руководство пользователя, Страница: 118 / 160

Chapter 6 - Fuselage - Translations (includes
mechanics)
6.13 - Extras Page 113
cutouts allow the passage of fuel, brake, and other lines or wires between the spar area
and the fire wall area. Attach the end panels to the floor mount with a two-inch width of
two-ply BID at the corners, and adjust the frame mount fit to the interior surface of the
fuselage (close these openings to prevent screws or nuts from going under the floor in
most parts. operations).
As mentioned earlier, the
rudder pedal location shown in the
drawing is the nominal value used
in the prototype. If the early riders
are taller, or shorter, the location of
the rudder pedals can be adjusted
to provide the desired distance
between the seats and the nominal
location.
rudder pedal. The floor panel, however, must be installed with the “ears” front side against
the firewall as shown (in this way it becomes part of the engine mounting hardening
system). When located in this position, glue the floor assembly in place with two-inch-
wide two-ply BID tape. Crimp the fiberglass surface over the firewall and wood
reinforcement to prepare these surfaces for bonding. Glue the “ears” to the firewall with
a two-layer pattern with double overlay on the firewall at the engine mounting location.
This will add four layers to the lower engine mounting points.
6.13 Extras
RUMBER SUSPENSION
Install the helm in the same location as the previous temporary installation. The
flange on the right side of the post rudder channel section must be drilled for mounting
the hinges. drill holes to match the hinges, and use cap screws