Valco baby MCP-25/MS, Руководство пользователя

Страница: 15 / 179

Valco Cincinnati
4-1
Introduction
This section describes the basic features of the MCP-25/MS Control.
Front-Panel
Section 4—Basic Features
11 12 13 14 8 10 6 5
16 15
2 4
1
7 9 3
17 18 19
Description of Front-Panel Features
1 Valve-selection buttons
• If the control is in the purge mode , pressing and holding a valve-selection button activates the valve. The
valve is active as long as the button is pressed. Purge mode can be selected during production (the
control continues to apply glue patterns). The green LED illuminates to indicate the valve is activated.
• If the control is in the valve-selection mode , pressing a valve-selection button causes the programmed
glue-pattern information to be sent to the valve(s) selected. Pressing the valve-selection button a second
time will turn off the selected valve(s).
• The valve-selection buttons have a special function when copying a glue pattern in the “glue-pattern-edit
menu.” A pattern can be copied to a valve by selecting a valve-selection button with a blinking light.
2 Valve on/off LEDs
The LED next to the valve number illuminates when the valve is open (on). The LED goes out when the valve
is closed (off).
3 Valve-selection LEDs
LED off = Valve has not been selected.
LED green = Valve has been selected.
LED red = Fault indicator. Check the fuse, voltage, etc. (see Section 13 — Diagnostic Menu ).