Valco baby MCP-25/MS, Руководство пользователя

Страница: 74 / 179

Section 8 — Setup Menu MCP-25/MS
Valco Cincinnati 8-6 MC051 (July 2002)
Encoder Configuration
To configure the encoder, follow these steps:
1. At the setup screen (Figure 8-7), press F2
(Enc.1) to configure encoder 1, or press F3
(Enc.2) to configure encoder 2. The encoder-
configuration screen displays (Figure 8-8).
2. Use the arrow keys to move the cursor to the
parameter you want to change (refer to
Encoder Configuration Parameters on the
following page).
3. Use the numeric keypad to type a value for the
parameter, or use the scroll buttons to select a
value.
4. Either press the ENTER button or wait 3
seconds. The following message displays:
“The change takes effect when the control is
turned on again!”.
5. Press F3 (OK) to confirm the message.
Notes! If you place an [X] in a field, you must
press the ENTER button for the new
value to take effect. Before the new
value goes into effect, you can press the
ESC button to recover the previous
value.
6. The control is set by default to minimum
speed (Vmin) for the valves. After changing
encoder data, check the minimum speed for
each valve.
F2
Figure 8-7. Setup Screen
Figure 8-8. Encoder-Configuration Screen
F3
Valve conf i gur ation Valve output s: 4
Nr Type Ton Toff Tmin CF Vmin M
[ms] [ms] [ms] [%] m/min
1
2
F1
F2 F3
F4 F5
07HP/24
07HP/24
9.0
9.0
7.5
7.5
1.0
1.0
100
100
0001
0001
Pres.
Sensor
>>>
Enc 1. Enc 2.
Encode r conf igurati on
Modi fy onl y at m ac hine stop !
00 01 Impul ses = 0001 mm -> Set
Vmax= 2000 m/m in , R esol uti on=1.00 mm
D i rectio n r ecogni ti on : yes [ ] no [ ]
Z-S ignal on Sc anner 5 : yes [ ] no [ ]
F1 F2 F3
F4 F5
Pres. Sensor
>>>
Enc 1. Enc 2.