Valco baby MCP-25/MS, Руководство пользователя

Страница: 66 / 179

Valco Cincinnati
7-1
MC051 (July 2002)
Section 7—Operation
Introduction
This section of the manual contains job creation and adjustment procedures for MCP-25/MS control operations.
Creating a New Job
To create a new job, follow these steps:
1. After the unit has been turned on, use either the F1 or F2 button to adjust the contrast of the screen.
2. General setup:
2a. Press the setup menu button.
2b. Enter the PIN code.
Note! The MCP-25 has a default setting for each field in the setup menu. You can use these values or
change the values if you like.
2c. Use the arrow keys to select a field.
2d. Use the numeric keypad to enter new values. (Refer to
Section 8—Setup Menu for a description of the
setup parameters.)
3. Enter the scanner assignment:
3a. Press the glue pattern edit menu button.
3b. Enter a scanner assignment for glue valve.
3c. Press the ENTER button. The cursor moves to the cell-to-gun field.
4. Enter the cell-to-gun dimension:
4a. Enter a cell-to-gun value (the distance from the scanner to the glue valve) for scanner 1/valve 1.
Note! This value must be entered in either millimeters or 1/100".
4b. Press the ENTER button.
5. Enter the repeat factor:
The repeat factor is the number of identical, consecutive glue patterns to be applied (based on the first glue
pattern).
5a. Enter “1” for one pattern or multiple patterns of different lengths.
5b. Enter “2,” “3,” “4,” etc. for multiple, identical, consecutive patterns.
6. Enter the pattern-delay information:
6a. Use the arrow buttons to move the cursor down to the first delay field.
6b. Enter a value for delay 1 (the distance from the leading edge of the product to the start point of the
first glue pattern).
Note! The delay value must be entered in either millimeters or 1/100", depending on unit configuration.
6c. Press the ENTER button.