Toshiba TOSVERT VF-MB1, Инструкция по эксплуатации

Страница: 253 / 350

E6581697
G-5
7

List of logic input terminal function settings
Parameter
programmed value
Parameter
programmed value
Positive
logic
Negative
logic
Function
Positive
logic
Negative
logic
Function
   
No function
   
Factory specific coefficient *1
   
Forward run command
   
Integrating wattmeter (kWh) display
clear
    Reverse run command     Trace back trigger signal
   
Standby
   
Light-load high-speed operation
prohibitive signal
    Reset command     Holding of RY-RC terminal output
   
Preset-speed command 1
   
Holding of OUT-NO terminal output
    Preset-speed command 2     Frequency UP *2
    Preset-speed command 3     Frequency DOWN *2
   
Preset-speed command 4
   
Clear frequency UP/DOWN *2
   
Jog run mode
   
Coast stop command
    Emergency stop by external signal     Forward/reverse selection
    DC braking command   Run/Stop command
   
2nd acceleration/deceleration
 
Frequency reference command forced
switching
    3rd acceleration/deceleration   Frequency setting mode terminal board
   
2nd V/F control mode switching
 
Command mode terminal board
    2nd stall prevention level   Parameter editing permission
   
PID control prohibition
 
Fast stop command 1
    External thermal error input   Fast stop command 2
   
Forced local from communication
 
Traverse permission signal
    Operation hold (hold of 3-wire operation)   Factory specific coefficient *1
   
PID integral/differential clear
 
Forward deceleration
   
PID characteristics switching
 
Forward stop
    Forced run operation   Reverse deceleration
   
Fire speed operation
 
Reverse stop
    Acceleration/deceleration suspend
signal
 to  Factory specific coefficient *1
   
Power failure synchronized signal
 
Parameter editing prohibition
    Logic sequence function trigger signal   Parameter reading prohibition
*1: Factory specific coefficients are manufacturer setting menus. Do not change the value of these parameters.
*2: Active when
 (frequency setting mode selection) =  (UP/DOWN from external logic input) is set.
The frequency setup range is from  to  (upper limit frequency). The acceleration/deceleration time
relative to the set frequency is  /  while the acceleration/deceleration speed is not switched.
☆
Refer to section 11.6 for details about the input terminal function.