Toshiba TOSVERT VF-MB1, Инструкция по эксплуатации

Страница: 337 / 350

E6581697
M-4
13
(Continued)
Error code Failure code Problem Possible causes Remedies

The motor parameter  ,  ,  ,

,

are not set correctly.

Set the left column parameters correctly
as a motor name plate and make an auto-
tuning again.

Set parameter
f416
to smaller 70% of
the present value, and execute the auto-
tuning again.

The motor with the capacity of 2 classes
or less than the inverter is used.

The output cable is too thin.

The inverter is used for loads other than
those of three-phase induction motors.

Set the left column parameters correctly
as a motor name plate and make an auto-
tuning again.

Then set f400 = 1 , when trip occurs.

The motor is not connected.

Connect the motor.

Check whether the secondary magnetic
contactor.

The motor is rotating.

Make an auto-tuning again after the
rotation of the motor stops.




0028
0054
0055
0056 Auto-tuning error

Parameter
pt
=6 is set and High speed
motor is connected.

Choose the higher power range drive.
(1 class up drive is recommended.)

A ground fault occurs in the output cable
or the motor.

Check the cable and the motor for ground
faults.

Overcurrent of dynamic braking resistor

Increase the deceleration time
dec
.

Set the supply voltage correction
f307
to 1 or 3 .

0022 Ground fault trip

When inverters are fed by AC power
supply and connected with common DC
bus link, unnecessary trip occurs.

Set the parameter f614 to 0
“Disabled”.
* 

002F Step-out (for PM
motor drive only) 
The motor shaft is locked.

One output phase is open.

An impact load is applied.

Using the DC braking function.

Unlock the motor shaft.

Check the interconnect cables between
the inverter and the motor.

Prolong the acceleration / deceleration
time.

Turn off the Step-out function when using
the DC braking function or change the DC
braking to Servo lock function.

003B Safe torque off error

Error of safe torque off circuit

Contact your Toshiba distributor.

0029 Inverter type error 
It may be a breakdown failure.

Contact your Toshiba distributor.

002D Over speed fault 
The input voltage fluctuates abnormally.

Over speed fault due to the overvoltage
limit operation.

Check the input voltage.

Install an optional dynamic braking
module.
*


0032 Brea in analog signal
cable 
The input signal from VIC is equal to or
less than the

setting.

Check the VIC signal cable for breaks.
Also, check the input signal value or
setting of

.

0033 CPU communications
error

A communications error occurs between
control CPUs.

Contact your Toshiba distributor.

0034 Excessive torque
boosted

The automatic torque boost parameter

setting is too high.

The motor has too small impedance.

Set a lower automatic torque boost
parameter

setting.

Make an auto-tuning.

0035 CPU fault 2 
The control CPU is defective.

Contact your Toshiba distributor.

0037 Optional unit fault 2 
An optional device is defective.

Contact your Toshiba distributor.

003A CPU fault 3 
The control CPU is defective.

Contact your Toshiba distributor.

0040 PTC fault 
PTC thermal protection is occurred.

Check the PTC in motor.

0045 Servo lock fault 
The motor shaft is not locked in servo lock
operation.

Reduce the load in servo lock operation.
* This marking trips can be selected valid or invalid by parameters.
(Continued overleaf)