Tokyo Keiki UFL-30, Руководство по установке и эксплуатации

Страница: 116 / 166

III-7
Digital output St’d/option Standard
Output 1 One-way output mode
Following data is output per set output cycle
Instantaneous flow rate, forward/backward flow totalized value
and various warnings.
(flow meter mode: linear flow rate and various
warnings)
Note: Instantaneous flow rate will change to velocity value in case of velocity
mode. No totalized values available.
Output 2 Intercommunication mode
Connection to PC enables setting of flowmeter unit, setting menu
and reading of measurement values and operation status.
Output type RS232C (non-insulated output
Output cycle 1 to 3600 seconds possible. (output 1 only)
Communication
speed
4800 bps, 9600 bps or 19200 bps selectable
Data bit length 8 bit/1 stop bit
Parity check EVEN
Format TOKYO KEIKI Original Format (ASCII)
MODBUS (Selectable; only for Output1)
Synchronization Asynchronous
Cable length
Up to 3m
Note: To comply with EC directives, use less than 3m cable.
Multi-path
measurement
St’d/option Option
Quantity 2 path or 4 path
Details 2 path:
- 1 additional pulser module required and installed in main unit
(total 2 modules).
- Transducer, fixture, extension cable for each path required.
4 path:
- External multi-path junction box is required and 2 special
coaxial composite cables are connected to the flowmeter main
unit.
- Transducer cable connected in junction box by BNC
connector.
- 3 additional pulser modules required and installed in main unit.
(total 4 modules).
- Transducer, fixture, extension cable for each path required.