Tidal Engineering Synergy Compact, Техническое руководство

Страница: 40 / 346

Synergy Controller Technical Manual, Revision H
Page 40
6.2.1.1 Channel Sensor Selection
The
SETUP\Calibration\Calibration Channel n\Channel n Sensor Select parameter determines the
sensor for channel n. The sensor is selected from the Sensor Selection screen as follows:
1. Select the Module from the list in the first column.
2. Then select the sensor or the sub-module from the Sensor list.
3. When necessary, select the sensor from the sensor list in third column.
Olympic
(High Resolution Inputs)
RTD 1
RTD 2
Analog 1
Analog 2
Analog 3
Analog 4
TC 1*
TC 2*
UUT
(Up to 64 T-type T/Cs)
Module 1 Thru 8
Sensor 1 thru Sensor 8
Machine Inputs
(Low Resolution Inputs)
Low Res 1 thru 8
Digital Inputs
Dig. In. 1 thru 16
Channels
(PV)
Act CH 1 thru Act CH 4
Setpoints
(SP)
Setpt CH 1 thru Setpt CH 4
Virtual Sensors
Dual Press.
Wet Bulb/Dry Bulb
Virtual Kft
UUT Sensor Selection
♦
To select a sensor from the UUT
Thermocouple module, Select UUTs from
the Module column, and then select the
UUT Module (1 thru 8) and then the
Sensor (1 thru 8).
Note: * Direct Thermocouple Inputs are not
available on Synergy Micro 2.
Use the TE1908 Thermocouple Signal Conditioner
if thermocouples are required.