Tidal Engineering Synergy Compact, Техническое руководство

Страница: 276 / 346

Synergy Controller Technical Manual, Revision H
Page 276
RS-485
To communicate over RS-485, plug a serial cable into the serial port on your PC and connect the other end
to the serial port on the chamber.
On the SimpleComm, select the RS-485 tab and set
the port number to the same port number specified
on your PC. To determine the port settings on the
PC, go to Start/Settings/System, select the
hardware tab, select Device Manager and expand
the Ports icon.
The Synergy Controller’s RS-485 port settings are
hard-coded to: 9600 baud rate, no parity, 8 data
bits and 1 stop bit. Next, set SimpleComm’s 485
address to the same address as the Synergy
Controller. The RS-485 Mode must be set to User
Comms, if it reads UUT Sensors, change the
setting.
Once the settings are complete, press the
SimpleComm’s
Connect button. The status label
will read: port open.
RS-232
To communicate over RS-232, plug a serial cable into your PC and connect the other end to the serial port
on the chamber.
On the SimpleComm, select the RS-232 tab and
set the port number to the same port number
specified on your PC. To determine the port
settings on the PC, go to Start/Settings/System,
select the hardware tab, select Device Manager
and expand the Ports icon.
The Synergy Controller’s RS-232 port settings are
hard-coded to: 19200 baud rate, no parity, 8 data
bits and 1 stop bit. RS-232 does not need address
settings.
Once the settings are complete, press the
SimpleComm’s
Connect button. The status label
will read: port open.