Tidal Engineering Synergy Compact, Техническое руководство

Страница: 295 / 346

Synergy Controller Technical Manual, Revision H
Page 295
Connecting the Synergy Controller to Your Network
Plug a network patch cable into your Synergy Controller and the other end into your hub or router. Make
sure it is powered on then boot your Synergy Controller. If your Synergy Controller is set to DHCP it should
be assigned an address automatically.
Verify DHCP IP Addressing
To confirm that the Synergy Controller was
assigned an address, press the
COMM button on
the controller touch screen and select the Ethernet
folder icon. You should see a screen similar to the
one below. Verify that each field contains non-zero
numbers.
The address in the Ethernet Address field is the IP
Address of the controller. Use this address when
connecting to the Synergy Controller over Ethernet.
If the addresses are blank or 0.0.0.0 then the Synergy Controller did not obtain an IP address from the
DHCP router. If this is the case, review the previous sections to make sure you have set up the DHCP router
properly. If that doesn’t solve the problem, verify the settings with your network administrator.
Synergy Controller TCP/IP Server Setup
To set up the Synergy Controller for ASCII
commands over TCP/IP, press the
COMM button at
the bottom of the Synergy Controller’s touch screen.
The Comm Screen window will appear.
Select the TCP/IP Server folder icon.