Thermo Scientific Heracell 150i, Руководство по эксплуатации, Страница: 54 / 156

Operating Instructions | HERAcell® 150i / 240i
5 Start-up 5 Start-up 5 Start-up
54
50115191 A / 08.2009
5.5 Installing the optional center strut
HERAcell ® 240i for split inserts
If HERAcell
®
240i is equipped with the optional 6-
segment insert, two center struts [1] with perforations
at each side must be installed.
In this case the shelf support rails must be installed to
the support rails at the sides and at the left and right
side of the strut.
The support rails marked with the diamond shape are
installed at the rear panel of the device.
1. A pressure spring keeps the upper rectangular
guide [3] of the center strut under tension. Insert
this guide into the receptacle [2] in the work space
ceiling und push it slightly upward so that it is
pushed into the center strut.
2. Then, position the lower rod guide [5] of the
center strut into the hole [6] in the work space
floor and remove spring tension.
3. The center strut is stabilized by the spring
pressure.
Configuration with split inserts:
For versions with split inserts, bottle
turning devices cannot be installed.
Fig. 23: Center strut installation