Thermo Scientific Heracell 150i, Руководство по эксплуатации

Страница: 51 / 156

Operating Instructions | HERAcell® 150i / 240i
5 Start-up 5 Start-up 5 Start-up
51
50115191 A / 08.2009
5.4 Installing the optional bottle turning
devices HERAcell ® 240i
1. Align the roller insert so that the roller holder [8]
and the crossmember [7] are flush and facing the
work space opening.
2. Slide the roller insert with both guide rails [5] onto
the shelf supports.
3. Slightly raise the roller insert so that the
withdrawal stop can be routed over the shelf
support.
4. Insert the drive roller [6] into the right receptacle
and connect the cable [4] to the corresponding
control unit
a .
5. Insert the four idle rollers [3] the into receptacles
and position the rollers in the receptacles in
accordance with the bottle diameter.
6. Place the bottles onto the rollers. To ensure that
the bottles will not be shifted against each other
by the rotation, the bottoms of the bottles should
contact the stop disks [2] of the rollers and the
cylinder necks [1] should contact the rubber stop
rings [8]. The stop ring can be positioned
accordingly on the roller.
Set speed of the bottle turning device:
7. The rotating speed of the bottle turning devices is
set depending on two parameters:
– Diameter (of the bottles used),
– drive roller set value.
Use of diagram:
8. The diagram shows the common bottle diameters
as different graphs (ascending straight).
– Set the desired speed at the Y axis. Read the
corresponding set value (in %) from the X axis
at the point of intersection of the Y value with
the specific graph.
Fig. 21: Installing the bottle turning devices