Thermo Scientific Heracell 150i, Руководство по эксплуатации

Страница: 50 / 156

Operating Instructions | HERAcell® 150i / 240i
5 Start-up 5 Start-up 5 Start-up
50
50115191 A / 08.2009
5.2.2 Installing the shelf supports:
1. Fig. 19: Insert the shelf supports [3] into the
perforations [1] of the support rail with the bar
facing down.
2. Make sure that the two vertical elements [2] of the
shelf support are flush with the support rail.
Installing the shelves:
1. Push the shelf [4] onto the shelf supports with the
tilt protection [5] facing the rear panel of the
device. The tilt protection [5] is also used as a
guide for the shelf.
2. Slightly raise the shelf so that the withdrawal stop
[6] can be routed over the shelf supports.
3. Make sure that the shelf support is positioned in
the two tilt protections in a way that allows it to
move freely.
5.2.3 Levelling the device
1. Position a bubble level onto the center shelf or
onto the roller holder.
2. Rotate the adjustable device stands using the
supplied 24 mm wrench until the shelf is
positioned horizontally in all directions. Perform
the adjustment of the device stands from left to
right and from rear to front.
5.3 Installing the gas humidification
(optional, only for O
2
/N
2
-control)
Fig. 20: The gas humidification [1] is installed to the
water tray parallel to the rear panel of the device. The
position to the right side wall is predetermined by the
hose length.
1. Install hose [2] to the sleeve of the gas
humidification and then to the sleeve [3] of the
device-integral oxygen or nitrogen supply line.
2. Place gas humidification immediately to the rear
panel of the device and align it parallel to the rear
panel.
Fig. 19: Shelf support installation
Fig. 20: Installing gas humidification