Tandberg Data Magnum 224, Руководство по эксплуатации продукта, Страница: 39 / 278

A
UGUST
2007 M
AGNUM
224, S
TORAGE
L
IBRARY
T24,
OR
S
TORAGE
L
OADER
2U
21
C
ONNECTING THE
L
IBRARY TO
E
THERNET
C
ONNECTING THE
L
IBRARY TO
E
THERNET
The library’s Remote Management utility (described in Chapter 4 ) allows you
to remotely monitor operations when the library is connected to an Ethernet
network. You can also create diagnostic listings and upgrade library firmware.
For information about upgrading firmware and creating diagnostic listings,
see
page 183 .
To connect the library to Ethernet using the provided cable:
1. 1. 1. 1. Insert one end of the cable into the library’s Ethernet port until you hear it
snap into place. The Ethernet port is located on the back of the library.
2. 2. 2. 2. Connect the other end of the cable to the network or directly to the server
you plan to use to run the library’s Remote Management utility or upload
firmware.
When you perform library configuration, you will configure the library’s
Ethernet interface (see
page 63 ).
C
ONNECTING THE
L
IBRARY TO THE
USB P
ORT
You can use the library’s USB port to download firmware to the library or tape
drive(s) and to perform diagnostics.
To connect the library to the USB port:
1.
1. 1.
1.
Insert one end of the cable into the library’s USB port until you hear it snap
into place.
Figure 2-8
Ethernet port (SCSI library shown)
Ethernet port
Figure 2-9
USB port (Fibre Channel library shown)
USB port