Tandberg Data Magnum 224, Руководство по эксплуатации продукта, Страница: 193 / 278

A
UGUST
2007 M
AGNUM
224, S
TORAGE
L
IBRARY
T24,
OR
S
TORAGE
L
OADER
2U
175
R
EMOVING
C
ARTRIDGES
W
ITHOUT
P
OWER
Note: LibTool may return an error message with some tape drives, but still
returns the requested information.
Download and install the tools from www.tandbergdata.com . The readme file
that accompanies the program (or the online help for the Windows version)
provides instructions for using the tools.
For questions regarding software configuration, operation (including how to
perform a backup operation), or installation—contact your software provider.
R
EMOVING
C
ARTRIDGES
W
ITHOUT
P
OWER
If you need to remove cartridges from the library when power is unavailable,
either due to a general power failure or a failure of the library’s power supply,
use one of these methods.
R
EMOVING
A M
AGAZINE
W
ITHOUT
L
IBRARY
P
OWER
To remove a magazine without library power:
1.
1. 1.
1.
If your library is installed in a rack, disengage the screws securing the rails
to the back of the rack, and slide the library forward approximately six
inches to expose the access slots in the side of the library (see
“Attaching the
Library to the Rails” on page 16 ).
2. 2. 2. 2. Insert the tip of a small flat-blade screwdriver into the bottom of the small
slot and gently lift up to disengage the locking mechanism (see
Figure 7-15 ).
Each side of the library has an access slot—one for each magazine. The
magazine will disengage and move a short distance out of the library.
Caution
This method is for EMERGENCY magazine removal only. If you are unsure if the
robot was idle when the power went out, be aware that there is a chance that the
robot was moving a cartridge into or out of the magazine. If so, the magazine will
not manually eject, and
you should not use force . Contact Tandberg Data Technical
Support if you encounter this situation (see “Contacting Tandberg Data
Corporation” on page iii ).
Figure 7-15
Manual magazine release
Use caution not to insert
tip of screwdriver too far
or you will damage
components inside the
library.