Tandberg Data Magnum 224, Руководство по эксплуатации продукта, Страница: 184 / 278

166
P
RODUCT
M
ANUAL
1017472
C
HAPTER
7—M
AINTENANCE
c. c. c. c. Disconnect the power cord, the SCSI or Fibre Channel cable(s), and the
terminator (if present).
d.
d. d.
d. Remove the tape drive cover plate. Set the plate and the screws aside.
2.
2. 2.
2.
Removing the tape drive —
a. a. a. a. Pull the tape drive a short distance out of the library, and then disconnect
the serial cables (
S
) from the tape drive(s) that you are replacing.
b. b. b. b. Disconnect the power cables (
P
) from all of the tape drives.
c. c. c. c. While holding the cables out of the way, pull the tape drive straight out
of the library.
d.
d. d.
d.
Disconnect the 10-pin serial cable from the library and discard it. Do not
reuse the serial cable .
3. 3. 3. 3. Installing the new tape drive —
a. a. a. a. Locate the serial cable (
S
) that came in your replacement kit and attach
it to the appropriate serial connector inside the library.
Full height tape drive—see Figure 7-1
Half height tape drive—see Figure 7-2
Figure 7-8
Tape drive cover plate (Fibre Channel library)
Power OFF
Disconnect
power cord
Tape drive
cover plate
Screws
(press the 0 )
Back of library
Screws
Caution
Be certain to support the tape drive as you remove it from the library. LTO Ultrium
tape drives weigh several pounds each.