Tandberg Data Magnum 224, Руководство по эксплуатации продукта, Страница: 265 / 278

A
UGUST
2007 M
AGNUM
224, S
TORAGE
L
IBRARY
T24,
OR
S
TORAGE
L
OADER
2U
247
T
APE
A
LERT
F
LAGS
Set Time Fail The library could not set the
time on a USB file or
directory.
1. Ensure that the USB device is securely
inserted and retry the operation.
2. Retry with another USB device.
If the error persists, contact Technical Support
(see
page iii ) or your service provider.
Slot Empty The command cannot be
completed because the slot
does not contain a cartridge. Select a slot that has a cartridge and retry the
operation.
Slot Full The command cannot be
completed because the slot
already contains a cartridge. Do one of the following:
ƒ
Empty the slot and retry the operation.
ƒ
Select a slot location that does not contain a
cartridge and retry the operation.
Software Error The library has experienced
a fatal microcode error.
1. Reset the library and retry the operation. See
page 134 for reset instructions.
2. If the error persists, contact Technical Support
(see
page iii ) or your service provider.
System Error The library has experienced
a fatal error.
1. Reset the library and retry the operation. See
page 134 for reset instructions.
2. If the error persists, contact Technical Support
(see
page iii ) or your service provider.
System Fan The library has detected that
the system fan is not
operating properly.
1. Power cycle the library.
2. If the error persists, contact Technical Support
or your service provider.
System Timeout An library operation took
too long.
1. Reset the library and retry the operation. See
page 134 for reset instructions.
2. If the error persists, contact Technical Support
(see
page iii ) or your service provider.
Tape Overflow The robot is full and no
empty slot can be found. Remove one or more cartridges.
See
“Loading Cartridges into the I/E Port” on
page 116 (to remove a single cartridge).
See “Loading Cartridges into a Magazine” on
page 120 (to remove multiple cartridges).
Terminated The operation has been
stopped by the user. Retry the operation, if desired.
Unknown Drive The library does not
recognize the tape drive.
1. Verify that the tape drive settings in the “Drive
Configuration menu match the type of tape
drive(s) installed.
2. Ensure that you have a valid SCSI ID set for
the tape drive. See
“Changing the SCSI IDs”
on page 49 .
Table E-1
Library error messages (continued)
Error Message Description Corrective Action