Tandberg Data Magnum 224, Руководство по эксплуатации продукта, Страница: 261 / 278

A
UGUST
2007 M
AGNUM
224, S
TORAGE
L
IBRARY
T24,
OR
S
TORAGE
L
OADER
2U
243
T
APE
A
LERT
F
LAGS
I/E Port Unlocked Import/Export element is
unlocked. Close I/E Port and retry the operation.
See
“Loading Cartridges into the I/E Port” on
page 116 .
Invalid Cartridge An attempt was made to
load an incompatible
cartridge or a spent cleaning
cartridge into a tape drive
and the cartridge was
ejected.
ƒ
Remove the cartridge from the library and
replace it with one that is compatible with the
tape drive. See
“Tape drive cartridge read/write
compatibility” on page 115 .
ƒ
If you were attempting to import a cleaning
cartridge, insert a cartridge with cleaning cycles
remaining on it.
Invalid Data The library detected that the
data read from the USB file
is not the desired data.
1. Ensure that the correct data is in the file,
re-write the file to the USB device, and retry
the operation.
2. Retry with another USB device.
If the error persists, contact Technical Support
(see
page iii ) or your service provider.
Invalid NVRAM An operation couldn’t be
completed because the
stored parameters are not
valid.
1. Reset the library and retry the operation.
2. Use “Restore Defaults” from the Library
Settings menu to refresh the library settings.
3. If the error persists, contact Technical Support
or your service provider.
Invalid Password The password you entered
does not match the saved
password that is protecting
this system. Enter the valid password.
See
“Setting up an operator panel password” on
page 73 .
Magazine Unlocked Magazine is unlocked. Close the magazine and retry the operation.
See
“Loading Cartridges into a Magazine” on
page 120 .
No Cleaning Tape The library cannot clean the
tape drive since there is no
cleaning cartridge in the
fixed cleaning cell. Import an LTO cleaning cartridge and then move
it to the fixed cleaning cell.
Use only LTO cleaning cartridges with LTO tape
drives.
See
“Inserting and Moving Cartridges” on
page 116 .
No Empty Cell The requested move cannot
be completed because there
is no empty cell to act as the
destination for the move.
ƒ
Use either SCSI or front panel commands to
empty a cell and retry the command.
ƒ
Select a different type of element as the
destination.
Table E-1
Library error messages (continued)
Error Message Description Corrective Action